1967 VW Beetle Sedan
This juicy iconic 67' Beetle was hand picked out of Southern California back in 2000.
This gentleman was very tied to the Volkswagen community and Volkswagen racing and professionally ran a race-shop.
He started to hand pick his vendors to help with his 7 year journey-restoration.
This was done to the highest level and with a strong focus of the legendary DKP cars.
Perfect and subtle and brutally fast, this is not your normal run of the mill 67.
Classic looks and stance, we have all seen t before and it is timeless and well respected the world over.
Out back is a 2276cc built with 48 IDA's built by Proformance Motoring in Orange CA.
Specs:
82x94 Flanged Dee Crank.
Cima 94's pistons with TS Rings.
Engle FK-10 Cam with Scat Lifters
Melling Full Flow Oil Pump.
Eagle 5.352 Rods.
42x37.5 SE Heads 9.75:1 Compression 055 Deck.
Serp Belt and Pulleys.
009 Bosch Distributor with Electronic point-less upgrade Blue Coil.
Berg 1.5 oil Sump.
Chromoly head studs and push rods.
Scat spring-loaded Push Rod Tubes.
New Weber 48 IDA's.
New AS41 engine case.
High Torque heavy duty starter.
Rancho Gearbox...not off the shelf,was special ordered to handle 200hp+.
Sway-Away hardened axles, close ratio with all Berg bracing and Traction Bar.
Rear limit straps were installed.
This is a serious performance car.
Detail level is strong every place you look inside or out.
CB Performance Ball Joint Narrowed Adjustable Front Beam with Empi Disc Brake Kits with parking brakes, new parking brake cables for short swing axles.
Fresh Empi Fuchs and Continental touring tires.
Pan first blasted and then powder coated in gloss black. Full use of Dynamat sound deadening material.
All new brake lines and Emergency brake cables. Installed line-lock.
Like jewelry
$1200 spent on all new stainless steel fasteners-hardware
Empi GT wheel
Crow harnesses all the way around
Small harness plug-in located by hand brake handle to connect Air-Fuel-Ratio hand held unit.
Roll cage
The paint color is BMW "Imola Red" and wow does it pop!!
Access doors for carb tuning in the rear fender wells
Better than new!
All new wiring harness
Impressive car from top to bottom
Custom A-1 Ceramic Header with O2 bung,system exiting to the front right side running board area.
System 1 remote oil filter plus Kymco electric remote oil cooler.
BMD serpantine belt and pully system
Black California plates
Kustoms 1 Upholstery installed all new interior with custom piping in a bone-color.
All seat frames,brake and clutch arms,Ron Lummus 5 Point Bolt-In Roll Bar
and parking brake handle powder-coated Mercedes Gray before install. Powder coating by PPC Primo Powder Coating Huntington Beach.
West Coast Metric was involved in all new front to back rubber,running board kits and body rubber mounting kits.
Wow!
Convertible deck lid mounted on the car .
1500 miles on the car since completion.
This is one impressive 67.
Not for the faint of heart or wallet, this is no child's toy.
This is a full tilt pro built street machine that is ready to show or go!
Asking
$28,500
For More Info...CALL
951 767 1600
or Email oldbug@earthlink.net